Air Filter Remote Control Holder

After installing my new Record Power AC400 air filtration system in the workshop, the next logical step was to find a space for the remote control to live. What better place than directly underneath it, where I hopefully can’t lose it, so I got to work creating a custom made, 3D printed bracket just for

Keyring Point of Sale Stand

After producing the keyrings recently, I decided to make a small stand to show them off and here’s what I came up with. All in all, I like the result, maybe a coat of paint, or a stain / finish would make it stand out (get it) more, but like I said, I just wanted

Spray Can Holder

After collecting a few spray paint cans lately, I needed a place to store them, so they don’t take up valuable space on the bench in the workshop. Not exactly how I envisaged it coming out, but it seems to fit the bill nicely with a little space to spare for future cans and a

Lumber Storage Holder

After a small accident involving my lumber rack, I decided to upgrade it by adding a couple of bungee cords to prevent the big sheets of plywood falling onto you as try to grab a small piece from the bottom. Hopefully no more accidents now.

Work Bench Drawer

Moving back on to my work bench project, I decided it would be a lot more useful if it had a drawer under the table saw to store the spanners, mitre gauge and other bits and pieces used on, or around the table saw, so they’re all within arms each, instead of having to hunt

Forstner Bit Holder

Instead of having to find the cardboard box of Forstner bits and empty them out all over the bench to find the required size, I made yet another holder to make them all easily accessible and to hand near the drill press.

Apple Watch Holder / Charger

To try and tidy up another loose dangly cable on my bedside table, I wanted to make a very simple Apple Watch holder which hides the cable and provides a recess for the charging disc to sit in, but doesn’t interfere with the connection to the watch which could prevent it charging properly. This is

Workshop Storage Cupboard

Following on from my earlier post (My First Routed Rebate / Groove), where I gave you a sneak peak at my latest project and a chance to guess what the project would be (did you guess it would be for a cupboard?). Here’s my (not quite complete) workshop storage cupboard, which I couldn’t wait until

Flush Cut Saw Holder

Here’s another French cleat holder, this time for my new flush cut trim pull saw.

Charging Station

Another little French cleat holder for the wall, this one solves the ‘where do I put the battery charger’ problem. So instead of placing the battery charger on the floor, I can now just put it on this holder where I can see it and swap it out when full.